REDUCING HYDRANT VALVE

The reducing hydrant valve is served at a higher floor in the tall building The water pressure of hose nozzle in a higher floor is usually over 7 kgf/cm² The reducing design is to protect the nozzle pressure constant in 7 kgf/cm² which is construct as a orifice and coil spring to adjust the water pressure.

The valve is made and test in accordance with CNS 13579. Material body cast bronze JISH5111 BC/ASTM B584 C83600, hand wheel aluminum alloy die casting ASTM B85 A413.0 i.e., JIS H5302 ADC 1

AVH 401F 1 1/2 PT thread female inlet with 1 1/2 Quick connector male outlet, working pressure 16kgf/cm test pressure 32kgf/cm²

LP HYDRANT VALVE

The LP (Low pressure) hydrant valve is served at a lower fold in the building as a fittings to indoor hydrant, may also use as a irrigation in the agriculture.

It is installed in the indoor hydrant box and drains water conveniently through connecting the fire hose. To top it off, its simple design and strong interior structure can give the high endurance,

Alarm Valve

It offers a wide range of usage : Sprinkler enclosed facility, open facility, spray facility, etc.

It is combined the merit of moisture type and the demerit of dry type, so it gives the high safety, good-working and durability. To top it off, it is used in the prompt preparing facility and diverse bridge facility

It offers a wide range of usage : Sprinkler enclosed facility, open facility, spray facility, etc.

It is combined the merit of moisture type and the demerit of dry type, so it gives the high safety, good-working and durability. To top it off, it is used in the prompt preparing facility and diverse bridge facility

Next Page